JRR John Reed Racing MoTeC M130 PNP Kit Can-Am Maverick X3 Turbo 2017-2020 Rotax 900 ACE

This kit fits 2017-2020 Can-Am Maverick X3 Turbo models

Full control of all engine parameters including fuel, timing, boost, launch, etc with live tuning

Support for staged injection - run a second set of injectors for high power or alcohol fuels

Closed loop lambda control - using optional lambda sensor

Flex fuel control - adjust fuel, timing, boost, cold start and more based upon ethanol content

Supports running two separate fuel systems - each with a different type of fuel

Launch control - trigger from vehicle speed or add an external switch

Nitrous control - various parameters supplied to control nitrous. Includes nitrous bottle heater relay control based on nitrous pressure

CO2/wastegate pressure control - controls a fill/bleed solenoid setup to control wastegate pressure

Water injection control - with fail safe for boost/timing/fuel based on pressure sensor feedback

Knock control

Full control of cooling fan activation points. 

Supports the use of third party lambda controllers with 0-5v output

Supports momentary buttons

Datalogging

Supports direct input from a MoTeC/Racegrade CAN keypad

You (or your tuner) have full control, at all times, of every aspect of engine operation along with the data to make informed tuning decisions. No more sending ECUs out for a mystery re-flash, and hoping it is optimum for your exact setup. Knowledge is power - race (and play) smart!